Blueberry, similar to v01, but large enough to accommodate an HQ cam, and wide enough for a regular camera board with illuminators and IR cut filter.
Printed in blue PETG, the parts have a nice finish, and the lights seep out through the translucent material, especially at night. PETG should also weather better than PLA, but the real reason it is in PETG and it is blue is that I had it sitting around and needed to use it. This and the next few cams are the Bubble Gum series of my RPi cam housings.
The base has a holder for the same DROK 5A 12v to 5v buck converter held in with double-sided tape, and has built up standoffs. The tapered design adds stability, so that it is not a tall, thin structure.
This is the first camera housing attempt. In all, it is not bad, and a number of the design elements have carried forward. The basic shape has not changed, and the base sliding in to the groove at the bottom of the cowl is still used
Blueberry, similar to v01, but large enough to accommodate an HQ cam, and wide enough for a regular camera board with illuminators and IR cut filter. Printed in blue PETG, the parts have a nice finish, and the lights seep out through the translucent material, especially at night. PETG should also weather better than PLA, but the real reason it is in PETG and it is blue is that I had it sitting around and needed to use it. This and the next few cams are the Bubble Gum series of my RPi cam housings. The base has a holder for the same DROK 5A 12v to 5v buck converter held in with double-sided tape, and has built up standoffs. The tapered design adds stability, so that it is not a tall, thin structure.
2n2222 Bipolar (BJT) Transistor NPN 40V 600mA 300MHz 625mW Through Hole TO-92-3
